Engineer programming via the browser
Installation & Configuration Manual
17.6.3 Wireless
Wireless sensor detection (868 MHz) on the SPC panel is provided by wireless
receiver modules which may be factory fitted on the keypad or on the controller, or
by installing a wireless expander.
1. Select Configuration > Hardware > Wireless > Wireless.
2. See table below for further information.
The number of the sensor enrolled on the system
(1 = first, 2 = second, etc.)
A unique identity number for that sensor.
The type of wireless sensor detected
(magnetic contact, inertia/shock, etc.)
The zone to which the sensor has been enrolled.
The status of the battery in the sensor (if fitted).
The status of the supervisory operation (OK = supervisory signal received,
Not Supervised = no supervisory operation).
The signal strength received from the sensor (01=low, 09=high).
Note: Although it is not possible to enroll a device with a signal strength less
than 3, devices whose signal drops below 3 after enrollment are not
dropped.
Performable actions
Click to view the wireless sensor Log. See page [âž™ 176].
Click to open the list of unenrolled wireless devices.
1. Select Status > Hardware > Wireless > WPA.
2. The identity of each enrolled WPA and its status displays.
To Next Page
Loading...
Need help?
General
