Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
See also
 Quick Start ATP Configuration for EN50136 ATS [➙ 274]
 Configuring Event Profiles [➙ 286]
 Event Exception Definition [➙ 288]
 Configuring Command Profiles [➙ 290]
 FlexC Status [➙ 179]
 Configuring an EN50136-1 ATS or Custom ATS [➙ 276]
17.10.2.1 Operation Mode
The system uses the store-and-forward method when communicating events.
The SPC Alarm System sends events to SPC Com XT and requires an
acknowledgment from SPC Com XT before the SPC Alarm System considers the
event to have been successfully transmitted. SPC Com XT only acknowledges the
event after it has successfully written the event to the SQL database. SPC Com XT
then forwards the event to the SPC Com XT Client and Sur-Gard interfaces.
17.10.2.2 Quick Start ATP Configuration for EN50136 ATS
FlexC provides the following out of the box features that enable you to get FlexC
up and running quickly:
To Next Page
Loading...
Need help?
General
