Engineer programming via the browser
Installation & Configuration Manual
The physical status (OK, Fault) and the programmed status (OK, Isolated,
Inhibited) of the keypad cable connection to the expander.
The physical and programmed status of the expander cabinet tamper.
Applies only to Keypads with a PACE receiver installed.
Keypad panic alarm status.
Keypad Fire alarm status.
Keypad medical alarm status.
Keypad PIN tamper alarm status
Performable actions
Click the button to restore all alerts on the panel.
Click this button to inhibit a fault condition. The inhibit operation will disable
that fault or zone for one arming period only.
Inhibit operation is not available in Security Grade EN 50131 Grade 3.
Click this button to isolate that zone. Isolating a zone will de-activate that zone
until such time as the zone is explicitly de-isolated again. It is recommended
that you exercise caution when isolating zones as those zones will not be
active every time the system is SET.
17.6.2.4 Door Controller Status
1. Select Status > Hardware > X-Bus Status.
2. Select the Door Controllers tab.
A list of detected door controllers is displayed.
This ID number is a unique identifier for the door controller.
To Next Page
Loading...
Need help?
General
