Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
Tick this box to enable the embedded web server on the panel.
Enter the Port number that the web server is 'listening' on. By default this is set
to 443.
Tick this box to enable encryption operation on embedded web server. By
default this is enabled. With TLS enabled, web pages can only be accessed by
using ‘https://’ prefix before typing the IP address.
Tick this box to enable the Telnet server. (Default: Enabled)
Note: Using Telnet without a comprehensive knowledge can damage the
controller configuration; this should only be used if the user has sufficient
knowledge or is being instructed by someone with such knowledge.
Enter the number of the Telnet port.
Tick this box to enable Simple Network Management Protocol (SNMP).
(Default: Disabled)
Enter the Community ID for the SNMP protocol. (Default : Public)
Tick this box to enable Enhanced Network Management Protocol (ENMP).
(Default : Disabled)
Enter the ENMP port number (default: 1287).
Enter the password for the ENMP protocol.
Check this box to enable network changes to be made with ENMP protocol.
17.10.1.2 Ethernet
The Ethernet port on the controller can be configured from both the browser and
keypad interfaces. An Ethernet connection with the SPC controller can be
established using a direct connection or a LAN connection.
To Next Page
Loading...
Need help?
General
