Vanderbilt SPC53 Series User Manual

17
Engineer programming via the browser
Configuring Communications
302
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
Dial Delay
Enter the time period (in seconds) that the system will wait before redialling
after a dial attempt has failed.
Dial Lockout
Enter the time period (in seconds) that the system will suspend dialling when
the maximum number of failed dial attempts is reached. Enter a value of ‘0’ to
continually attempt dialling.
Event Logging Options
Comms Status
Log all communication availability.
EDP Commands
Log all commands executed through EDP.
A/V Events
Log when Audio/Video verification events are sent to Receiver.
A/V Streaming
Log when Audio/Video live streaming begins.
Keypad Use
Log when remote keypad is activated.
17.10.4 PC Tools
17.10.4.1 SPC Pro / SPC Safe
1. Select Communications > PC Tools > SPC Pro/SPC Safe.
2. Configure the fields as described in the table below.
Enable
Tick this box to enable SPC Pro to connect to
the panel.
Engineer Access
Tick this box if engineer access must be
granted to allow SPC Pro to connect to the
panel.
Password
Enter the password for SPC Pro connection.
The password is checked by the panel every
time SPC Pro attempts to connect to it. If the
password programmed in this field matches the
password programmed on the panel, then the
connection will be allowed (default: ).
Enable IP
Tick this box to enable a connection to the
panel using Internet Protocol (IP).
IP Port
Select the IP port that SPC Pro will use to
connect to the panel.
SPC Safe
For further information about configuration of the SPC Safe please refer to the
SPCS410 Installation & Configuration Manual.
1. Click the Enable SPC Safe button.
2. Configure the fields as described in the table below.

Vanderbilt SPC53 Series Specifications

General

Brand	Vanderbilt
Model	SPC53 Series
Category	Power Supply
Language	English