Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
The settings displayed will depend on the type of connection that the ports are
used for. The settings are described in the following sections:
17.10.2 FlexC
®
The SPC Flexible Secure Communications Protocol (FlexC) enables
communications for an Internet Protocol (IP) based single or multiple path Alarm
Transmission System (ATS). An ATS is a reliable communications link between a
Supervised Premises Transceiver (SPT e.g. Ethernet integrated onto the SPC
panel) and a Receiving Centre Transceiver (RCT e.g. SPC Com XT or the SPC
Connect server, www.spcconnect.com). A FlexC ATS consists of a primary Alarm
Transmission Path (ATP) and up to nine backup Alarm Transmission Paths
(ATPs). It enables:
Two-way transfer of data between the SPT, for example the SPC panel over
Ethernet, and the RCT, for example, the SPC Com XT server or the SPC
Connect server, www.spcconnect.com.
Communication monitoring of a complete ATS and individual ATPs.
SPC intrusion panels support FlexC over IP with any of the following interfaces:
Ethernet
GSM modem with GPRS enabled
PSTN modem
To Next Page
Loading...
Need help?
General
