Mounting system equipment
Installation & Configuration Manual
5. Connect one end of the battery leads to the battery + and - terminals and the
other ends to the corresponding + and - inputs of the PSU.
When installing the battery, always connect the positive (+) lead to the battery first
before connecting the negative (-) lead. When removing the battery, always
remove the negative (-) lead first before removing the positive (+)
6. Connect the loose ends of the attached temperature monitoring leads to the
battery temperature monitoring inputs on the PSU.
6.4 Mounting a keypad
Please refer to corresponding installation instruction.
6.5 Mounting an expander
Please refer to corresponding installation instruction.
To Next Page
Loading...
Need help?
General
