Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
1. Select Communications > Communications > Ethernet.
The following window will be displayed.
2. Configure the fields as described in the table below.
Enter the IP address of the panel.
Enter the subnet mask that defines the type of network address structure
implemented on the Local Area Network (LAN).
Enter the IP address of the IP gateway if one exists. This is the address that IP
packets will be routed through when accessing external IP addresses on the
internet.
Click this Button to enable dynamic address assignment on the panel.
Enter the IP address of the DNS server.
17.10.1.3 Modems
The SPC panel provides two on-board modem interface connectors (primary and
backup) that allow you to install PSTN or GSM onto the system.
After a factory default, during the process of initial setup of the system with the
keypad, the panel detects if it has a primary or backup modem fitted, and if so, it
displays the modem type and automatically enables it (or them) with the default
configuration. No other modem configuration is allowed at this stage.
To program the modem(s):
Note: A modem must be installed and identified. (See section Installing plug-in
modules [➙ 87])
1. Select Communications > Communications > Modems.
2. Click Enable and Configure.
To Next Page
Loading...
Need help?
General
