Engineer programming via the browser
Installation & Configuration Manual
Input zones: attributes
Each zone on the SPC can be assigned an attribute that determines the properties
of that zone.
To assign an attribute to a zone:
1. Select Configuration > Hardware > Controller > Attributes.
The following window will be displayed:
2. Check the box beside the preferred attribute.
The attributes presented on this page will depend on the type of zone selected.
For a list of assignable attributes see page [➙ 352].
17.9.1.2 Editing an output
1. Select Configuration > Hardware > Controller.
2. Configure the fields as described in the table below.
To Next Page
Loading...
Need help?
General
