Domestic, Commercial and Financial mode default settings
Installation & Configuration Manual
Amount of current from Aux output using two 24 Ah batteries
(SPC535x/635x)
Amount of current from Aux output using a 27 Ah battery
(SPC535x/635x)
Amount of current from Aux output using two 27 Ah batteries
(SPC535x/635x)
Values listed as N / A indicate that the selected battery does not have the capacity
to power the minimum load of just the SPC controller for the given standby time.
See page [âž™ 334] for maximum load of devices and modules.
Only sealed cell valve regulated battery types to be used.
For EN compliance the supplied current needs to be supported by the battery for
required stand by time.
23.5 Domestic, Commercial and Financial mode default
settings
This table gives the default zone name and types on the controller for each mode
of operation. All zones on connected expanders are be categorized as unused until
explicitly configured by the installation engineer.
To Next Page
Loading...
Need help?
General
