Engineer programming via the keypad
Installation & Configuration Manual
4. Press SELECT to delete the user profile.
16.21 SMS
The SPC system support SMS alerts to be communicated from the panel to the
engineer and selected users’ mobile phones (SMS events) in addition to allowing
users to control the SPC system remotely via SMS (SMS control). These two
features work hand in hand as it allows the user to respond to a SMS notification
without the need to be physically at the premises.
A maximum of 32 (SPC4xxx), 50 (SPC5xxx) or 100 (SPC6xxx) SMS IDs can be
configured for each panel. An SMS-enabled modem and an appropriate system
and user configuration are required to enable SMS communications.
Depending on the SMS AUTHENTICATION mode selected (see OPTIONS
[➙ 111] menu), SMS user authentication can be configured to use various
combinations of the user’s PIN and Caller ID or SMS PIN and Caller PIN.
The SMS notification can operate with a PSTN modem if the PSTN operator
supports SMS over PSTN whereas SMS control will need a GSM modem at the
panel. A GSM modem will support both SMS notification and control.
SMS control
The SMS control can be set up so that a remote user can send an SMS message
to perform the following actions at the panel:
Setting / unsetting
Enable / disable engineer
Enable / disable manufacturer access.
Mapping gate on/off.
SMS events
The SMS notification can be set up to send a range of events that occur on the
system such as:
Alarm activation
Confirmed alarms
Fault & tamper
Setting & unsetting
Inhibit & isolate
All other types of events
16.21.1 Add
A modem is installed and identified by the system.
The function SMS Authentication is activated in OPTIONS [➙ 111].
1. Scroll to SMS -> ADD and press SELECT.
2. Select a user to add for SMS operation.
3. Enter an SMS NUMBER for this user and press ENTER.
4. Enter an SMS PIN for this user and press ENTER.
Keypad indicates that SMS details are updated.
To Next Page
Loading...
Need help?
General
