Engineer programming via the browser
Installation & Configuration Manual
17.9.5.4 Adding an area group
You can use area groups for configuring multiple areas. So the configuration must
not be done for every single area.
Only if the option (multiple) Areas is activated.
Select Settings > Areas > Area groups.
1. Click on the Add button.
2. Enter a description for the group.
3. Select the areas that are to be assigned to this group.
4. Click Add.
To use the area groups for the Comfort Keypad, activate all Areas in the Areas
field under Configuration > Hardware > X-BUS > Keypads > Type: Comfort
Keypad.
17.9.6 Calendars
Calendars are used for scheduling time-based control for multiple panel operations
as follows:
Automatic setting and/or unsetting of areas
Automatic setting and/or unsetting of other panel operations including triggers,
enabling of users, zones, physical outputs, etc.
At any particular time, any schedule within the calendar can be ‘active’ if its time
conditions are satisfied.
Each week of the year is assigned an ordinal number. Depending on the fall of
days within a month, there may be 52 or 53 weeks in one year. The SPC calendar
implementation conforms to the ISO8601international standard.
Configuring calendars
Select Configuration > Calendars.
A list of configured calendars is displayed:
To Next Page
Loading...
Need help?
General
