Engineer programming via the keypad
Installation & Configuration Manual
4. Scroll to ACCESS CONTROL and press SELECT.
The following sections provide programming steps found within the access control
option of the selected user.
Add Card manually
If the card format of the card number is known, the card can be created manually.
The site code of the card is configured for the user profile that is assigned for this
user.
1. Scroll to ADD CARD
2. Press SELECT.
An empty card has been added and can now be edited.
Learn Card
Only cards with supported card formats can be learned.
If the card number or the card format is not known, the card can be read and its
information learned.
1. Scroll to LEARN CARD.
2. Press SELECT.
3. Select the door that the card will be presented.
4. Press SELECT.
The new card can be presented at the entry or the exit reader of the selected
door.
5. Present the card at a card reader at the selected door.
The information for the new card is learned.
Edit Card
If an access card is already assigned to a user it can be changed via the keypad:
1. Scroll to EDIT CARD.
2. Press SELECT.
3. Edit the desired user setting shown in the table below.
4. Press BACK to exit.
Access Control
Enter card number. Enter 0 to unassign this card.
To Next Page
Loading...
Need help?
General
