Engineer programming via the browser
Installation & Configuration Manual
A new calendar is created with the same configuration as the original calendar.
You can provide a new description for the new calendar and edit the calendar
configuration as required.
Week Types
Calendars are configured by assigning an optional Week Type for each calendar
week. Up to three Week Types may be defined for each calendar. Not all weeks
must have a Week Type (i.e. a Week Type may be ‘None’). There is a system
maximum number of 64 calendar configurations.
To configure a week type
1. Click Week Types.
2. Enter the desired times for setting / unsetting or for triggers. Use time
guidelines for Automatic Setting/Unsetting of Areas (see page [➙ 254]), or for
Automatic Setting/Unsetting of other Panel Operations (see page [➙ 254]).
Up to three week types may be configured.
3. Click Save and then Back.
4. Select the desired week type from the drop down menu for each of the required
scheduled weeks in the calendar.
5. Click Save.
6. Click Back.
See also
Automatic setting/unsetting of areas [➙ 254]
Automatic setting/unsetting of other panel operations
[➙ 254]
Exceptions
Exceptions or exception days are used to configure automatic setting schedules for
exceptional circumstances outside of the normal weekly schedules defined in the
calendars. Exceptions are defined with a start and end date (day/month/year) and
up to four on/off timing periods for different panel operations including automatic
setting/unsetting of areas or the switching on/off of triggers or outputs. A maximum
of 64 exceptions can be configured on the system.
Exceptions are generic entities that can be assigned to one or more calendars.
When an exception is assigned to a calendar, the exception settings override any
calendar configuration for that start and end date period with both dates inclusive.
Configuring Exception Days
1. Select Configuration > Calendars > Exceptions > Add.
The following window will be displayed.
2. Configure the fields as described in the table below.
To Next Page
Loading...
Need help?
General
