TLS-450 Setup and Operation Screens Manual
98
Tank Setup - AccuChart II
Update Schedule
Descriptions of the available AccuChart II calibration update methods are listed below.
• Immediate - The active chart is updated every time AccuChart II generates a chart. Any resulting
changes in product volume go into effect immediately. The AccuChart II algorithm may generate
charts multiple times during the calibration period, so this schedule choice may cause repeated
changes in the reported volume of a tank. Alarms will be reported at the end of the calibration
period if no charts have been generated and applied
• Periodic - You can pick up to 4 target dates on which the best chart created by AccuChart II will
be made active. This will only occur if there is a chart available on that date. The target date
choices will be stored as relative dates to allow easy rescheduling. Although, AccuChart II may
generate charts multiple times during the calibration period, it is possible that at the update times
chosen in this schedule choice there will be no new chart available. No alarms will be reported
for a failure to apply a new calibration except for the final target date.
• Complete – At the end of the AccuChart II calibration period, AccuChart II will make the last chart
generated by AccuChart II active. If no chart is available at the end of the calibration period,
appropriate alarms will be generated.
To Next Page
Loading...
