TLS-450 Setup and Operation Screens Manual
72
Tank Setup - Environmental Tests
This screen provides a choice of disabling a tank test (default), or enabling SLD or CSLD tests for a
selected tank. Once a Tank Test Method has been chosen, the corresponding setup parameters for
either SLD or CSLD will be displayed in the data view area. Choosing a test enables this test and
provides the settings by which the test will be conducted. However, enabling a test is not the same as
starting the test, which may be started at a later point.
Tank Test Method
SLD (Static Leak Detection) tests - A single test that runs on demand, at a programmed time, or by pump
sense signal. Results are stored for leak test reports.
CSLD (Continuous Statistical Leak Detection) tests - leak tests are run continuously during idle tank times
and information is stored for leak test reports.
Allowable selections: Disabled, SLD, CSLD
Default: Disabled
To Next Page
Loading...
Need help?
General
