TLS-450 Setup and Operation Screens Manual
344
Software Maintenance - Install
The Install tab screen is use to control the installation of downloaded software. During the installation
process, several dialog boxes will be displayed to inform you of key events.
During Installation there must be no dispensing. However, the installation process only takes a few
minutes. Following installation, the console converts the setup databases. If new features are installed
and activated, setup(s) relevant to the new feature(s) will be required.
Installation Procedure
1. Touch the features on the list you want to install and then touch the Install button on the right side
of the screen.
2. Touch the OK button on the System Restart dialog box, or touch Cancel to abort the installation
or to reselect the feature(s) you want to install. The console will restart with the newly installed
features.
3. If you used the USB port of the Ethernet/USB module to install the new features, remove the USB
Adapter and put it in a safe place. Perform setup for the newly installed features.
4. If you used the CPU board printer's USB port to install the new features, turn off power to the
console. Open the left door of the console and remove the USB Adapter from the printer port and
reconnect the Printer cable. Close the left door and replace the two #8 taptite screws. Turn on
power to the console and perform setup for the newly installed features.
To Next Page
Loading...
Need help?
General
