TLS-450 Setup and Operation Screens Manual
142
The Auto detection mechanism may restrict the DIM Device Type choices available to choose from in
case a Device is already available in the slot.
If there is no Device in the slot, then all supported options for that specific slot will be
available. Setting the Device to "None" will also set all the common fields and button icons along the
bottom of screen to their default values thereby marking the entry as removed from the configured list
of DIM Devices (a Save is always needed for the changes to take effect. A message warning will be
shown to the user prior to the save).
Allowable selections: List, None
Default: None
Label
Enter a unique label for the DIM Device.
Allowable selections: Up to 20 alphanumeric characters
Default: Comm Device Identifier and number
EDIM Comm Devices – General (page 2)
DIM Protocol
Touch the down arrow to the right of this field and enter the applicable DIM Protocol for your DIM
card.
Allowable selections: See Table 1 below for valid options.
Default: Unknown
Baud Rate
Touch the down arrow to the right of this field and enter the applicable Baud Rate for your DIM card.
Allowable selections: See Table 1 below for valid options.
Default: Unknown
Data Bits
Touch the down arrow to the right of this field and enter the applicable number of Data Bits for your
DIM card.
Allowable selections: See Table 1 below for valid options.
Default: Unknown
Parity
Touch the down arrow to the right of this field and enter the applicable Parity for your DIM card.
Allowable selections: See Table 1 below for valid options.
Default: Unknown
Stop Bits
Touch the down arrow to the right of this field and enter the applicable number of Stop Bits for your
DIM card.
Allowable selections: See Table 1 below for valid options.