TLS-450 Setup and Operation Screens Manual
1
INTRODUCTION
This manual details currently available setup, operation and diagnostic screens for the TLS-450
Console. Depending on your console type and its installed features, you may only see (and be able to
program) some of the screens and/or fields. Skip over the material in this document that does not apply
to your particular installation. You cannot perform these setup procedures until the console, probes, and
sensors have been installed and configured.
IMPORTANT! READ ALL SECTIONS OF THE INTRODUCTION BEFORE ATTEMPTING ANY
SETUP PROCEDURES.
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and
setup the equipment discussed in this manual:
Installer (Level 1) Certification: Certification: Contractors holding valid Installer Certification are
approved to perform wiring and conduit routing; equipment mounting; probe, sensor and carbon canister
vapor polisher installation; wireless equipment installation; tank and line preparation; and line leak
detector installation.
ATG Technician (Level 2/3 or 4) Certification: Contractors holding valid ATG Technician
Certifications are approved to perform installation checkout, startup, programming and operations
training, system tests, troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems,
including Line Leak Detection. In addition, Contractors with the following sub-certification designations are
approved to perform installation checkout, startup, programming, system tests, troubleshooting, service
techniques and operations training on the designated system.
- Wireless 2
- Tall Tank
Warranty Registrations:
Warranty Registrations may only be submitted by selected Distributors.
Related Manuals
• TLS-450 Site Prep Manual (P/N 577013-879 )
• TLS-450 Setup, Operation Screens Manual (P/N 577013-940)
• TLS-450 Quick Help Guide (P/N 577013-969)
• Electronic Line Leak Detectors Application Guide (P/N 577013-465)
• TLS Consoles Point-of-Sale (POS) Application Guide (P/N 577013-401)
Safety Precautions
Safety and Alert Symbols are used throughout the help files to alert you to important system and safety
information. The table below explains symbols you may see when reading the setup and operation
instructions for this equipment.
To Next Page
Loading...
