TLS-450 Setup and Operation Screens Manual
235
Status
Possible messages that will display in the Status column:
• No Test
• Test Pre-start
• Test in progress
• Test complete
• Test abort
• Test pre-delay
• Test end delay
Minutes
Value range: 0.0 to 180.0 minutes
CSLD Test Status Refresh Rate
The CSLD Test Status data will be refreshed every 30 seconds.
Regulatory Compliance
Note: In-tank leak tests will not be declared a PASS unless the product level in the tank satisfies the
minimum product level defined in our Third Party certification for the leak test being performed. In-tank
leak tests performed with the product level below these minimum levels will be declared Invalid. Because
the minimum product level requirements vary with local, state, and federal regulations, you need to
ensure that the product level complies with the applicable regulations in your location.
To Next Page
Loading...
Need help?
General
