TLS-450 Setup and Operation Screens Manual
103
• Pump Sense - This input is used to identify a tank active condition. A pump sense input assignment
is required for this mode selection. There is no pump control assignment for this mode selection.
• External Pump Control - This mode is used to identify tanks that are line manifolded together.
Control of the pump is done externally to the console. There are no pump control or pump sense
input assignments for this pump mode selection.
Allowable selections: TLS Pump Control, Pump Sense or External Pump Control
Default: TLS Pump Control
Tank
Select the tank in which the selected pump is installed.
Note: There may be both configured and non-configured items on this drop-down list. Non-configured
items will be prefixed by a "!".
Allowable selections: Not assigned, or a selection from a list of available tanks.
Default: Not Assigned
Pump Control
This feature includes a list of pump controlling devices that respond to dispense requests. The list of
pump controlling devices will include relays that have been configured as pump controlling devices that
actuate the selected pump. Select from the list of relays for pump control that were assigned in Device
Setup - Relays.
Pump control relay assignments are usually unique for each pump. A warning dialog will display if the
pump control selected is already assigned to another pump - this alert is not an alarm or error since some
sites use a single pump control output for more than one pump.
This field is enabled for edit only when the Mode entry is "TLS Pump Control".
Note: There may be both configured and non-configured items on this drop-down list. Non-configured
items will be prefixed by a "!".
Allowable selections: Not assigned, or a selection from a list of available pump controlling devices.
Default: Not Assigned
Pump Sense
In this field you select how the console will determine when the pump is on or off. Inputs for pump sense
are selected from a list of defined or configured pump sense external inputs that were assigned in Device
Setup - External Inputs. Selecting a pump sense input enables pump sense for the selected pump. More
than one pump may use the same pump sense input. This feature is only enabled if Mode entry is "TLS
Pump Control" or "Pump Sense".
Note: There may be both configured and non-configured items on this drop-down list. Non-configured
items will be prefixed by a "!".
Allowable selections: Not assigned, or a selection from a list of available pump sense external inputs.
Default: Not Assigned
Line
This is a read-only field displaying either the line identifier of the selected pump, or "Not Assigned", if such
is the case. Note: Non-configured items will be prefixed by a "!".
To Next Page
Loading...
