TLS-450 Setup and Operation Screens Manual
341
Backup Button
At regular intervals (ideally once a day), insert your V-R Recovery USB Thumb Drive in the console's
USB port and touch this button to launch a non-disruptive backup operation of all system setup and data
files.
Restore Button
After replacing a console CF card, or after a system crash, insert your V-R Recovery USB Thumb Drive in
a console USB port and touch this button to launch a restore operation that reloads your console's system
software, setup and data files from your recovery thumb drive onto the CF card. The Restore operation
requires a 'quiet' station as it will cause an interruption in service. The console will be restarted before the
Restore has completed.
Revert To Previous Software Version Button
A copy of the previous (older) system software and databases is stored on your console's CF card. If the
current (newer) version of system software/features does not perform properly, the Revert-To operation
gives you the ability to revert to the previous software version stored in the CF card. The Revert-To
operation requires a 'quiet' station as it will cause an interruption in service for about a minute. No USB
devices are required for this operation.
After touching this button, a dialog box will alert you that this operation will cause an interruption in
service. If you reply with 'OK', the console will then check to ensure a previous version of the applications
exists, perform the Revert-To operation, notify you of its successful completion and restart the console. If
the Revert-To operation cannot be performed, a dialog box will display an error message.
To Next Page
Loading...
