1
Web Access Overview
Introduction
Veeder-Root's Web Access software lets you monitor the TLS-450 console remotely on
your PC anywhere you have internet access. Once connected to the console, you can
view many current and historical reports including tank inventory, tank delivery, sensor
status, alarm status and compliance in the language and units selected in console
setup. Web Access software does not provide access to console setup or diagnostics
screens.
All report screens support scrolling and are printable. Screens that have dynamic data
will refresh automatically. The refresh rate is dependent on the data viewed.
System Requirements:
a. Java Applet enabled in your browser.
For help enabling the applet go to
http://www.java.com/en/download/help/enable_browser.xml
b. JVM version 1.4 or newer installed.
To download the latest JVM version go to
http://java.sun.com/j2se/1.4.2/download.html
Connecting to the TLS-450 Console
You need the IP address of the console which can be found in Communcations Setup.
On the console’s Home screen, touch the Setup button, touch the Comm button, touch
the down arrow to see the next page of the General Tab Screen and you will see the IP
address (of the console) in the IP Address field.
Open Internet Explorer on your PC and enter the IP address of the console followed by
/tls.html (lowercase) in the URL bar of the browser as shown below:
http://xxxx.xxxx.xxxx.xxxx/tls.html
(where xxxx.xxxx.xxxx.xxxx = console IP address).
The TLS-450 Web Access home page will display the system status report (see
example below):
To Next Page
Loading...
