EasyManuals Logo

WAGO WAGO-I/O-IPC-C6 User Manual

WAGO WAGO-I/O-IPC-C6
322 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
WAGO-I/O-SYSTEM 750 Important Notes 17
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
2.3 Safety Equipment
All 750 Series components correspond to protection class IP 20. This includes
complete protection against accidental contact with electrical voltage and currents.
Pos: 28 /Serie 758 (Funk, IPC und PFC)/Wichtige E rläuterungen/Hinweise z um Betrieb 758-87x @ 10\mod _1312349532730_21.doc @ 75574 @ 2 @ 1
2.4 Notes on Operation
When integrating the 750 Series components in your machine or system, all the
currently applicable norms, regulations and guidelines shall be observed during all
activities. The emergency stop equipment shall remain effective in all operating
modes of the system and machine.
For protection from electromagnetic interferences
Connect your system to protective earth (PE) and
Ensure that the routing and installation of the supply and signal lines are
correct.
The following elements for 24V supply shall be present:
Outer lightning protection on buildings
Inner lightning protection of supply lines and signal lines
Safe electrical separation of 24VDC low voltage through PELV (Protective
Extra Low Voltage) or SELV (Safety Extra Low Voltage) voltage sources
Pos: 29 /Alle Serien ( Allgemeine Module)/W ichtige Erläuterungen/ Spezielle Einsatzb estimmungen für ETHERNE T-Geräte @ 12\mod_13366429 45500_21.doc @ 94792 @ 2 @ 1
2.5 Special Use Conditions for ETHERNET Devices
If not otherwise specified, ETHERNET devices are intended for use on local
networks. Please note the following when using ETHERNET devices in your
system:
Do not connect control components and control networks to an open
network such as the Internet or an office network. WAGO recommends
putting control components and control networks behind a firewall.
Limit physical and electronic access to all automation components to
authorized personnel only.
Change the default passwords before first use! This will reduce the risk of
unauthorized access to your system.
Regularly change the passwords used! This will reduce the risk of
unauthorized access to your system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGO WAGO-I/O-IPC-C6 and is the answer not in the manual?

WAGO WAGO-I/O-IPC-C6 Specifications

General IconGeneral
BrandWAGO
ModelWAGO-I/O-IPC-C6
CategoryI/O Systems
LanguageEnglish

Related product manuals