WAGO WAGO-I/O-IPC-C6 User Manual

WAGO-I/O-SYSTEM 750 Installing and Removing the I/O-IPC 49
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Pos: 36.22 /Serie 758 ( Funk, IPC und PFC)/Montieren/ Demontage 758-87x al lgemein 2 @ 10\mod_13124410236 49_21.doc @ 75856 @ 3 @ 1
6.6.2 Removing the I/O-IPC from the Mounting Rail
Remove the I/O-IPC from the mounting rail as described below:
1. First, disconnect from the power supply those parts of the system on which
you have mounted the I/O-IPC.
2. Then, pull the orange release tab (24) to remove the first 750 Series I/O
Module connected to the I/O-IPC from the mounting rail (A and B).
Pos: 36.23 /Serie 758 ( Funk, IPC und PFC)/Montieren/ Demontage 758-87x 2 Hand lung @ 10\mod_131520121438 9_21.doc @ 78111 @ @ 1
3. Press the four release levers (23) with both hands at the same time until they
stop and then remove the I/O-IPC from the mounting rail (C).
Pos: 36.24 /Serie 758 ( Funk, IPC und PFC)/Montieren/ Demontage 758-87x - FB Bi ld 2 @ 10\mod_131244109355 8_21.doc @ 75859 @ @ 1
…
…
…
Figure 17: Removing the I/O-IPC from the mounting rail
Pos: 37 /Dokumentati on allgemein/Glieder ungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
24
24
A
B
23
23
C

WAGO WAGO-I/O-IPC-C6 Specifications

General

Brand	WAGO
Model	WAGO-I/O-IPC-C6
Category	I/O Systems
Language	English