WAGO WAGO-I/O-IPC-C6 - Codesys Page; Table 29: Description of the Parameters of the Codesys Page

74 Configuration WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
9.1.3 "CoDeSys" Page
You will all information about the PLC program created in CoDeSys on that page.
Table 29: Description of the Parameters of the "CoDeSys" Page
Project Details
Date
Title
Version
Author
Description
Display of project information that the programmer entered in
the PLC program (in CoDeSys under Project > Project
Information...).
The information only appears in a executed PLC program.
Descriptive texts up to 1024 characters long are found under
"Description".
CoDeSys State
State
STOP: PLC program is not executed
RUN: PLC program is executed
Tasks
When running a PLC program, the following information appears for each task:
- Number of tasks
- Cycle count
- Cycle time (mcmsec)
- Cycle time min (mcmsec)
- Cycle time max (mcmsec)
- Cycle time avg (mcmsec)
- Status
- Mode
- Priority
- Interval (msec)
- Event
- Function pointer
- Function index