WAGO WAGO-I/O-IPC-C6 - Table 136: Description of the Configuration Scripts for HMI Settings

262 Appendix WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Table 136: Description of the configuration scripts for "HMI Settings"
Parameter Status Call Output/Input Validity
HMI Settings
Screensaver
read
get_touchscreen_config
display-state
on – display is turned on
(screensaver is off).
off – display is switched off
(screensaver is on).
Display Status
write
change_screen_state
display-state=<value>
<value>=on – switches the
display on immediately.
<value>=off – turns the
display off immediately.
Switching the display
on/off takes place
independently of the
screensaver activation.
Whether the displace is
turned off again after a wait
time, or is turned on again
after contact at the touch
screen, depends on whether
the screensaver function is
activated (see next point).
immediate