WAGO WAGO-I/O-IPC-C6 User Manual

204 Diagnostics WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Pos: 51.16 /Serie 758 ( Funk, IPC und PFC)/Di agnose/Diagnose Blinkcode 75 8-87x Blinksequenz @ 10\ mod_1312535550094_21. doc @ 76024 @ 333 @ 1
15.2.1 Progression of Blink Sequence
An error is always displayed as three blink sequences in a cyclic manner:
1. The first blink sequence (flickering) introduces the error message.
2. After a short break, the second blink sequence starts. The number of blink
pulses indicates the exact error code that describes the type of error.
3. After another break, the third blink sequence starts. The number of blink
pulses indicates the error argument, which provides additional descriptions
of the error, e.g. on which of the 750 Series components connected to the
I/O-IPC the error has occurred.
‘I/O’ LED is blinking (red)
Test o.k.?
No
Yes
‘I/O’-LED is shining (green)
ready for operation
2nd break
1st break
‘I/O’ LED
1st flash sequence (red)
(Introduction of theerror indication)
‘I/O’ LED
2nd flash sequence (red)
Errorcode
(Number of flash cycles)
‘I/O’ LED
3rd flash sequence (red)
Error argument
(Number of flash cycles)
Start-up
Switching on
thepowersupply
Figure 109: Blink sequence process diagram

WAGO WAGO-I/O-IPC-C6 Specifications

General

Brand	WAGO
Model	WAGO-I/O-IPC-C6
Category	I/O Systems
Language	English