WAGO WAGO-I/O-IPC-C6 - Table 140: Description of the Configuration Scripts for Port

268 Appendix WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Table 140: Description of the configuration scripts for "Port"
Parameter Status Call Output/Input Validity
Port
Telnet
read
get_port_state
telnet
Read the status of the
Telnet server:
enabled
disabled
Telnet Port
write
config_port
port=telnet state=<value>
Entries for <value> are:
enabled
disabled
immediate
CoDeSys-Webserver
read
get_port_state
codesys-webserver
Read status of the CoDeSys
web server. Entries for
<value> are:
enabled
disabled
CoDeSys
Webserver Port
write
config_port
port=codesys-webserver
state=<value>
Enable/disable the
CoDeSys web server.
Entries for <value> are:
enabled
disabled
immediate
FTP
read
get_port_state
ftp
Read the status of the FTP
server. Entries for <value>
are:
enabled
disabled
FTP Port
write
config_port
port=ftp state=<value>
Entries for <value> are:
enabled
disabled
immediate
CoDeSys
read
get_rts3scfg_value
PLC DisableTcpIp
Programming
Query the status of the
value for
"DisableTcpIpProgrammin
g" in the CoDeSys
configuration:
YES:
CoDeSys port is not used.
NO: CoDeSys port is used.
CoDeSys Port
write
change_rts_config
area=PLC disable-
tcpip=<value>
Entries for <value> are:
YES:
CoDeSys port is not used.
NO:
CoDeSys port is used.
read
get_rts3scfg_value
PLC TcpIpPort
Value set in the CoDeSys
configuration for the
TCP/IP port.
CoDeSys-Port
Number
write
change_rts_config
area=PLC
TcpIpPort=<value>
Change the value of the
TCP/IP port number.
Specify the TCP/IP port
number for <value>.
immediate