WAGO WAGO-I/O-IPC-C6 - Loading and Executing the PLC Program in Control (ETHERNET)

112 CoDeSys 2.3 Runtime Environment WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
11.6.5 Loading and Executing the PLC Program in Control
(ETHERNET)
Prerequisite:
The simulation mode is disabled (Online > Simulation).
You have connected the PC to the ETHERNET interface of the I/O-IPC via an
ETHERNET cable (RJ-45).
1. Click in the menu bar on Online and select Communication Parameters ...
The "Communication Parameters" window opens.
2. To create a communication, click on [New…] in the "Communication
Parameters" window. The window for creating a new channel opens.
Figure 15: Creating a new communication channel 1
3. Enter any name for your I/O-IPC in the "Name" field and click "Tcp/Ip...".
Then click [OK].
Figure 15: Creating a new communication channel 2