WAGO WAGO-I/O-IPC-C6 User Manual

WAGO-I/O-SYSTEM 750 Configuration 75
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
9.1.4 "TCP/IP" Page
On the page for TCP/IP configuration, change the parameters for the ETHERNET
configuration. To accept your entries, click on the [SUBMIT] button.
Table 30: Description of the Parameters of the "TCP/IP" Page
Common Configuration Data
Host Name
If you have chosen the dynamic assignment of an IP address
through DHCP, enter the host name of your PC here so that your
PC can connect to the ETHERNET network.
Default Gateway
None
X8
X9
This is where you select the interface that should be used as the
default gateway. The default gateway is used by the I/O-IPC if
the target address lies outside of the individual network.
Value Enter the address of the default gateway here.
DNS Server
Domain Name Set the domain name here.
DNS-Server 1, 2, …
Set the address of the DNS server here.
[CHANGE]: Accept the DNS address.
[DELETE]: Deletion of the DNS address (line is
removed).
Add DNS Server Add additional DNS addresses here.
TCP/IP Configuration Eth0/Eth1
State
Enabled Activate the corresponding ETHERNET interface here.
Disabled Deactivate the corresponding ETHERNET interface here.
Type of Address Configuration
Static IP
DHCP
BootP
Here, choose whether you would like to use a static or dynamic
IP address.
Static IP: Static IP address
DHCP and BootP: Dynamic IP address
Configuration Data
IP Address
Here, enter a static IP address. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.
Subnet Mask
Here, enter the subnet mask. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.

WAGO WAGO-I/O-IPC-C6 Specifications

General

Brand	WAGO
Model	WAGO-I/O-IPC-C6
Category	I/O Systems
Language	English