WAGO WAGO-I/O-IPC-C6 - Access over Telnet; Figure 102: DOS Console 1; Figure 103: DOS Console 2

182 Operating System WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Pos: 48.7 /Serie 758 ( Funk, IPC und PFC)/Betri ebssystem/Betriebssy stem Linux 758-87x IPC - Zugri ff über Telnet @ 11\mod_13 15392988383_21.doc @ 78770 @ 4 @ 1
14.4.1.1 Access over Telnet
In order to access the I/O-IPC over Telnet, use a terminal program such as
minicom (under Linux) or hyper terminal (under Windows).
For use of the hyper terminal, the following settings in the login interface have to
be adapted:
Host address: IP address of the ETHERNET interface of the I/O-IPC used
Connect via: TCP/IP
On top of that, you can also access the I/O-IPC through the textual console of
Linux or MS-DOS using Telnet. This procedure is described below:
Pos: 48.8 /Serie 758 ( Funk, IPC und PFC)/Betri ebssystem/Betriebssy stem Linux 758-87x IPC - Zugri ff über Telnet, Sc hritt 1 @ 11\mod_13153929977 59_21.doc @ 78773 @ @ 1
1. Connect the X9 ETHERNET interface of the I/O-IPC to your PC through an
ETHERNET patch cable.
Pos: 48.9 /Serie 758 ( Funk, IPC und PFC)/Betri ebssystem/Betriebssy stem Linux 758-87x IPC - Zugri ff über Telnet, Sc hritte 2 - 5 @ 11\mod_13153930745 09_21.doc @ 78779 @ @ 1
2. Open a console of your PC.
3. Enter the command telnet <IP-ADRESSE des I/O-IPC>.
Figure 102: DOS console 1
4. Enter your user name (See chapter "Access to the Linux console").
Figure 103: DOS console 2
5. Enter the password for your user. The Linux console of the I/O-IPC opens
in the HOME directory (
~
) of the selected user.
Pos: 48.10 /Dokumenta tion allgemein/Glied erungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1