WAGO WAGO-I/O-IPC-C6 - User Administration of WBM; Table 26: User Settings in the Initial State; Table 27: Access Rights for WBM Pages

72 Configuration WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
9.1.1 User Administration of WBM
To allow settings to be made by a select number of person only, limit access to
WBM functions through User Administration.
Passwords
Please change the passwords for your own use since the standard passwords are
documented in these instructions. Therefore, the standard passwords do not
provide sufficient protection (see section “Users ‘Page’”).
Table 26: User Settings in the Initial State
User Password
user user
admin wago
Access to the WBM pages is as follows:
Table 27: Access Rights for WBM Pages
WBM Internet Site Password
Information
CoDeSys
-
TCP/IP user or admin
ETHERNET user or admin
NTP user or admin
Clock user or admin
Users
HMI Settings
Administration
Firmware Update
Mass Storage
Downloads
admin
Port user or admin
Modbus user or admin
SNMP user or admin
I/O Configuration
WebVisu
-