WAGO WAGO-I/O-IPC-C6 - Information Page; Figure 32: Information Page (Example); Table 28: Description of the Parameters of the Information Page

WAGO-I/O-SYSTEM 750 Configuration 73
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
9.1.2 "Information" Page
After entering the IP address, the start page "Information" for web-based
management appears. This page provides information on the I/O-IPC and the
ETHERNET network.
Figure 32: "Information" page (Example)
The following table explains the parameters listed on the page:
Table 28: Description of the Parameters of the "Information" Page
Coupler Details
Order Number Item number for the I/O-IPC
Processor Type CPU used
Fieldbus Type Fieldbus type used
Firmware Revision Firmware status
License Information Notification that the runtime system CoDeSys is available.
Kbus FW Revision Firmware status of the I/O module interface
Network Details Eth0 (X8)/Eth1 (X9)
State Status of the ETHERNET interface (activated/deactivated).
Mac Address MAC address used to identify and address the I/O-IPC.
IP Address Current IP address of the I/O-IPC.
Subnet Mask Current subnet mask of the I/O-IPC.