WAGO WAGO-I/O-IPC-C6 - Page 258

258 Appendix WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Manual
Version 1.0.0
Table 132: Description of the configuration scripts for "TCP/IP"
Parameter Status Call Output/Input Validity
read
get_eth_config
eth0 config-type
Way be which the interface
receives its IP address:
static (static assignment),
dhcp (per DHC) or
bootp (per BootP)
Type of IP
Address
Configuration
Eth0
write
config_interfaces
interface=eth0
config-type=<value>
state=enabled
Switch on method by which
the interface receives its IP
address. Entries for <value>
are:
static (static assignment),
dhcp (per DHC) or
bootp (per BootP)
read
get_eth_config
eth0 ip-address
Address set for using a
static IP address (static IP).
IP Address Eth0
write
config_interfaces
interface=eth0
ip-address=<value>
Change IP address for static
IP. The <value> must
contain an IP address in the
format
number.number.number.
number.
read
get_eth_config
eth0 subnet-mask
Subnet mask set for using a
static IP address (static IP).
Subnet Mask
Eth0
write
config_interfaces
interface=eth0
subnet-mask=<value>
Change subnet mask for
static IP. The <value> must
contain an IP address in the
format
number.number.number.
number.
immediate
TCP/IP Configuration Eth1
See "TCP/IP Configuration Eth0". When calling, replace eth0 with eth1.