wsm M7040 - Page 502

ELECTRICAL SYSTEM
M6040, M7040, WSM
9-S33
Engine Rotation Sensor and Travel Speed Sensor
1. Check the engine speed meter and travel speed display.
2. It is OK if engine speed is displayed in the meter panel.
3. It is OK if traveling speed is displayed in the LCD monitor.
NOTE
• As for engine speed sensor and travel speed sensor are not
checking with circuit tester.
9Y1210143ELS0051US0
4WD Switch (ROPS Model)
1. Remove the 4WD switch (1).
1) Connector Voltage
1. Turn the main switch to ON position.
2. Measure the voltage with a voltmeter across the connector each
W/L terminal and chassis.
3. If the voltage differs from the battery voltage, the wiring harness
is faulty.
9Y1210143ELS0052US0
(1) Engine Rotation Sensor (2) Travel Speed Sensor
Voltage W/L terminal – Chassis
Battery voltage
(11 to 14 V)
(1) 4WD Switch
(2) 4WD Switch Connector
(Switch Side)
(3) 4WD Switch Connector
(Wiring Harness Side)
(4) Terminal W/L for Illumination
(5) Terminal W/L for 4WD
KiSC issued 07, 2012 A