wsm M7040 - Page 67

GENERAL
M6040, M7040, WSM
G-46
Front Cover Oil Seal Replacing Tool
Application
• Use to press fit the front cover oil seal.
NOTE
• The following special tools are not provided, so make them referring to the figure.
9Y1210143GEG0077US0
A 120 mm (4.7244 in.)
B 12 mm (0.4724 in.)
C 2.9 to 3.0 mm (0.1142 to 0.1181 in.)
D 10 mm (0.3937 in.)
E 80 mm (3.1496 in.)
F 10 mm (0.3937 in.)
G 95 mm dia. (3.7402 in. dia.)
H
78.9 to 79.1 mm dia.
(3.1063 to 3.1142 in. dia.)
I
57.971 to 57.990 mm dia.
(2.2823 to 2.2831 in. dia.)
J 50 mm dia. (1.9685 in. dia.)
K 15 mm dia. (0.5906 in. dia.)
L 30 mm dia. (1.1811 in. dia.)
M 15 mm (0.5906 in.)
N 90 mm (3.5433 in.)
O 2.5 mm (0.0984 in.)
P 0.349 rad (20 °)
Q
0.15 to 0.25 mm
(0.0059 to 0.0098 in.)
a Ra = 3.2 a
b Ra = 1.6 a
c 0.8 mm radius (0.0315 in. radius)
d 1.5 mm radius (0.0591 in. radius)
C0.5 Chamfer 0.5 mm (0.0197 in.)
C1 Chamfer 1.0 mm (0.0394 in.)
KiSC issued 07, 2012 A