Chapter 8: Configuration and Remote System Upgrades in Cyclone IV Devices 8–81
Document Revision History
May 2013 Altera Corporation Cyclone IV Device Handbook,
Volume 1
July 2010 1.2
Updated for the Quartus II software 10.0 release:
■ Updated “Power-On Reset (POR) Circuit”, “Configuration and JTAG Pin I/O
Requirements”, and “Reset” sections.
■ Updated Figure 8–10.
■ Updated Table 8–16 and Table 8–17.
February 2010 1.1
Updated for the Quartus II software 9.1 SP1 release:
■ Added “Overriding the Internal Oscillator” and “AP Configuration (Supported Flash
Memories)” sections.
■ Updated “JTAG Instructions” section.
■ Added Table 8–6.
■ Updated Table 8–2, Table 8–3, Table 8–4, Table 8–6, Table 8–11, Table 8–13,
Table 8–14, Table 8–15, and Table 8–18.
■ Updated Figure 8–4, Figure 8–5, Figure 8–6, Figure 8–13, Figure 8–14,
Figure 8–15, Figure 8–17, Figure 8–18, Figure 8–23, Figure 8–24, Figure 8–25,
Figure 8–26, Figure 8–27, Figure 8–28, and Figure 8–29.
November 2009 1.0 Initial release.
Table 8–28. Document Revision History (Part 2 of 2)
Date Version Changes
To Next Page
Loading...
