Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - SET - Set Variable Value

6-60 Writing the User Program ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
SET - Set Variable Value
or
Value
Operational Sign
Target Variable
Using this command, variables can be set from the program or copied
from another variable.
Valid inputs for ’Target Variable’ and the corresponding limit values:
Variable Type Number Minimum Value Maximum Value
User-programmable V600 to V999 -99999999.999999 +99999999.999999
Indicated Basis V500 to V507
V510 to V517
+600 +999
Indicated Offset
Factor
V508, V518 +0 +399
Indicated Index V509, V519 +0 +399
Fig. 6-29: Set Command: Valid Target Variable
Valid Inputs for ’Value’:
Variable Type Value Access Comment
User-programmable V600 to V999 Direct
Indicated Basis V500 to V507
V510 to V517
Indicated
Indicated Offset Factor V508, V518 Direct
Indicated Index V509, V519 Direct
System V000 to V199 Direct Only variable, according
to Fig. 6-1 and Fig. 6-2
No Variable Value
Fig. 6-30: Set Command: Valid Target Variable
See also Section 6.6 – Variables.
The program proceeds to the next instruction following the time period of
one cycle.
SET V600 = + V601
SET V600 = +12345678.123456