15-18 EMD Module (EcoX-Bus) ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
AZ0001f2_AE.WMF
Fig. 15-18: Assignment of the Pre-Assembled Cable (IKB0036), for the
Connection Between Drive Controller and EMD Module
Note: Switching between input/output module 1 (inputs/outputs
0 to 15) and module 2 (inputs/outputs 16 to 31) is done via a
bridge in the EcoX connector on the input/output module. For
more information, see Chapter 15.6 Assigning the
Input/Output numbers.
Connection of Input/Output Modules
Note: A pre-assembled cable IKB0037 is provided for the connection
from the Input/Output modules.
AZ0003f2.WMF
Fig. 15-19: Connection from Input/Output Modules
To Next Page
Loading...
