14-16 Display ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Special Displays
This display is called up when the Help key is pressed from the
Parameter menu.
If a parameter error is present, the parameter number of the erroneous
parameter is displayed when the F1 key is pressed.
Pressing F2 allows default values to be set.
Note: All parameters are overwritten!
As a precaution, another query is performed.
In addition, the system must be in Parameter Mode.
After pressing the OK key, the default parameters are set and the display
returns to the Parameter Menu.
Activate N1 F3
This way, the PLS positions that were edited during operation can be
transferred.
Start Adr. Text F4
On the first line, the start instruction of the user interface is defined.
(Default value is 500).
On the second line, the index for the following screens is shown, e.g.:
INDEX = 20
F1 = NC Instruction Number 500
F2 = NC Instruction Number 520
F3 = NC Instruction Number 540
etc.
M a n u a l .
P A R A M E T E R – H E L P
P A R . - E R R O R ( F 1 )
D E F A U L T - V A L U E ( F 2 )
A C T I V A T E N 1 ( F 3 )
S T A R T – A D R T E X T ( F 4 )
P a r a m e t e r .
! C A U T I O N !
P A R A M E T E R S W I L L B E
O V E R W R I T T E N
O V E R W R I T E ( O K )
B A C K ( E S C )
To Next Page
Loading...
