ECODRIVE03-FL*-04VRS Important directions for use 2-1
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
2 Important directions for use
2.1 Appropriate use
Introduction
All Rexroth controls and drives are developed and tested according to the
state-of-the-art of technology.
As it is impossible to follow the continuing development of all materials
(e.g. lubricants in machine tools) which may interact with our controls and
drives, it cannot be completely ruled out that any reactions with the
materials used by Bosch Rexroth might occur.
For this reason, before using the respective material a compatibility test
has to be carried out for new lubricants, cleaning agents etc. and our
housings/our housing materials.
The products may only be used in the manner that is defined as
appropriate. If they are used in an inappropriate manner, then situations
can develop that may lead to property damage or injury to personnel.
Note: Rexroth, as manufacturer, is not liable for any damages
resulting from inappropriate use. In such cases, the guarantee
and the right to payment of damages resulting from
inappropriate use are forfeited. The user alone carries all
responsibility of the risks.
Before using Rexroth products, make sure that all the pre-requisites for
appropriate use of the products are satisfied:
• Personnel that in any way, shape or form uses our products must first
read and understand the relevant safety instructions and be familiar
with appropriate use.
• If the product takes the form of hardware, then they must remain in
their original state, in other words, no structural changes are
permitted. It is not permitted to decompile software products or alter
source codes.
• Do not mount damaged or faulty products or use them in operation.
• Make sure that the products have been installed in the manner
described in the relevant documentation.
To Next Page
Loading...
