10-46 Interface ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
The PLS is initialized using the current PLS parameter data.
Format:
! s C I N I T N $ h h CR LF
Note: The command is accepted only in Manual or Automatic Mode.
An answer of Yes occurs immediately after acceptance of the command.
Polling Query
A query, in the shortest possible format, which cyclically polls all of the
controls connected to the RS485 bus.
The query:
:s CR LF
is answered with:
:snnnn CR LF
Meaning of the characters used:
nnnn = Diagnostic Error Number (Hexadecimal)
See also Diagnostics, Chapter 12.
SIS Protocol
In preparation
Re-Initialize PLS
To Next Page
Loading...
