2-2 Important directions for use ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Areas of use and application
For ECODR3-FLP Rexroth defines appropriate use as for precision
motion control of one axis.
Control and monitoring of (the) Ecodrive03 may require additional sensors
and actors.
Note: ECODR3-FLP may only be used with the accessories and
parts specified in this document. If a component has not been
specifically named, then it may not be either mounted or
connected. The same applies to cables and lines.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware
as specified in the relevant function descriptions.
The ECODR3-FLP has to be programmed before starting it up, making it
possible for the motor to execute the specific functions of an application.
The ECODR3-FLP has been developed for use in single axis drives and
control tasks.
Typical applications of ECODR3-FLP are:
• Metalworking
• Handling and assembly systems
• printing and paper processing machines
• automatic handling systems
• packaging and food processing machines
The ECODR3-FLP may only be operated under the assembly, installation
and ambient conditions as described here (temperature, system of
protection, humidity, EMC requirements, etc.) and in the position
specified.
2.2 Inappropriate use
Using the ECODR3-FLP outside of the above-referenced areas of
application or under operating conditions other than described in the
document and the technical data specified is defined as “inappropriate
use".
ECODR3-FLP may not be used if
• they are subject to operating conditions that do not meet the above
specified ambient conditions. This includes, for example, operation
under water, in the case of extreme temperature fluctuations or
extremely high maximum temperatures or if
• Rexroth has not specifically released them for that intended purpose.
Please note the specifications outlined in the general Safety
Guidelines!
To Next Page
Loading...
