10-14 Interface ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
10.2 Serial Interface
Overview
The drive controller is equipped with a serial interface. This interface is
used to program the drive. The following can be exchanged via this
interface:
• Parameter
• Programs
• Logic Task
• Cam
• Status Information
• Commands
These data are numbers-oriented and a single transfer occurs.
The interface can operate optionally in either
• RS232 Mode or
• RS485 Mode
Three different protocols are supported:
• Indramat SIS Protocol
user data transmitted in INTEL format
• ASCII Protocol
The precise structure is outlined in the following section.
• IDS protocol (RS232)
In conjunction with the Indramat IDS01 decade switch.
Interface Mode
Interface Protocol
To Next Page
Loading...
