4-10 General Instructions for Start-Up ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
H1 Display
The diagnostic message number appears in the two-digit seven-segment
display. The display format is shown in the graphic " Diagnostic Message
Priority Diagram ".
With the help of this display, it is possible to quickly determine the current
operating state without using a communication interface.
The operating mode is shown on the H1 display. If the drive complies with
the operating mode and no command was activated, "HA," "AU" or "PA"
appear on the display.
• PA – Parameter Mode
• HA – Manual Mode
• AU – Automatic Mode
Plain Text Diagnostic Message, Status Message 53
The plain-text diagnostic message contains the diagnostic message
number followed by the diagnostic message text, as shown in the
“Excessive Deviation” example.
It can be read out via the status message and is used for direct display of
the drive status at a user interface.
The language of the plain-text diagnostic message can be changed.
4.4 Language Selection
The language for the following items can be changed using Parameter
B000, Language selection
:
• parameter names
• description of commands
• diagnostic message text strings
Currently, the following languages are implemented:
Value of B000: Language:
0German
1 English
2 French
Fig. 4-6: Language Selection
To Next Page
Loading...
