14-18 Display ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Definition Assignment Function Example:
Display Text 0 -- N0500 TXT 0 0-0-2-00-20-ABCD
N0501 TXT 0 EFGHIJKLMNOPQRST
Display Variable 1 0 N0500 TXT 0 1-0-2-00-100-183
Display Marker 1 1 N0500 TXT 0 1-1-2-00-M2.00.0
Variable Value Editable 2 -- N0500 TXT 0 2-0-2-00-600-183
Draw Line 3 -- N0500 TXT 0 3-100-50-120-30
Draw Box 4 -- N0500 TXT 0 4-100-50-120-30
5--
6--
7--
8--
Number of Lines 9 0 N0500 TXT 0 9-0-6
Fig. 14-6: Specification
Using Assignments 1 and 2, a total of 10 definitions can be programmed.
Text Programming
N0500 TXT 0 0-0-2-00-04-ABCD
The TXT command and the following 0 are always hard-coded.
Parameters Description min. max.
0 Assignment: Text -- --
0 Reserved 0 0
2 Line 1 6(7)
00 Position 00 21
04 Number of Text Characters 01 20
ABCD Text -- --
Fig. 14-7: Text
In the 16-character writable portion of the TXT command, the display
specification is entered.
If more than 4 characters are to be shown as the text output, the next NC
instruction is used with this one as the text input.
Only characters which are permitted by the text command can be used as
text. (Capital Letters). In addition, the 5
th
text position may not be a space.
Permitted Characters
!"#%&()*+,-./:;<=>?@[]_
ABCDEFGHIJKLMNOPQRSTUVWXYZ
1234567890
To Next Page
Loading...
