ECODRIVE03-FL*-04VRS Parameters 9-19
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
AA05 Open Feed Roll I
M2.02.1 M2.02.2 M2.02.3 000 0
0 = Open mechanically
1 = Open electrically (in preparation)
Delay in ms (0 - 999)
Open Feed Roll OFF Å Meas. Wheel ON
Input Bit : Rolls Closed
(Acknowledgement)
00.00.0 = Delay Activated
M0 – M5 ; M8 ; I0 – I4 ; Q0 – Q3
Input Bit : Rolls Open (Automatic)
M0 – M5; M8 ; I0 – I4 ; Q0 – Q3
Output Bit: Rolls Open
M2, M3, M4
DKC21.3 : Q0.00.4-Q0.01.3
DKC 3.3 : Q2.02.0-Q2.05.7
EMD : Q3.00.0-Q3.03.7
Open Feed Roll in Automatic Mode
If pilot pins are used for precise positioning, the feed rolls must be open
while engaging the pilot pins. This can be accomplished by opening the
feed rolls (mechanically), or by preventing a connection from making
contact (electrically). For the latter, positioning is disabled and the power
to the motor is cut. (In preparation)
The pilot pins must hold the material in place before, and position it after
opening the rolls. The material must also be held in place at all times
while closing the rolls.
If a measuring wheel is used for positioning in conjunction with this
function, a motor encoder is used after the initial signal is received.
Switching back to Measuring Wheel Encoder occurs after the
acknowledgement signal "Rolls closed" or after the programmed delay
has expired. If a positioning command is called while the rolls are open,
the positioning move does not occur until after the acknowledgement
signal, at the earliest.
If an E-Stop, Fault, Immediate Stop, switch to Parameter Mode, or switch
to Manual Mode occurs, the programmed output is immediately cleared.
Diagnostic Message: „A- 00 11 – Feed Rolls Open“
System Marker Flags: M1.03.2 Rolls Open
To Next Page
Loading...
