ECODRIVE03-FL*-04VRS General Instructions for Start-Up 4-13
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Firmware Update in BTV04/05
Serial transmission to X3 takes place via the RS 232 port.
The communications parameters of the DOLFI program must be set as
follows:
Options Å Com-Port Connect baud rate 9600
Download baud rate 38400
Options Å Address Receiver 03
Caution: The BTV04*-DOL-01Vxx module must never be overwritten.
Setup Menu in the BTV
Enter the Setup Menu by
• pressing the F2 key while the BTV is in the initialization phase.
• OR by pressing Shift + F6
Enter the Setup Menu for Port 2 by pressing F1 (Serial Port Parameter)
and then F3 (Serial Port 2)
Set to
Address: 3
Baud Rate: 9600
Parity: off
Protocol: ASCII +SIS
Answer Delay: 1 ... 4
Timeout (ms): 400
Retry: 2
Group No.: 0
Max Unit: 0
Once these data are set, exit this input level by pressing ESC. These data
are saved by pressing F3 (Save Values and Reboot).
To Next Page
Loading...
