8-24 Functions ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Slave Axis
The axis follows the positions pre-set by the master axis encoder exactly.
With the FOL command, this function can be turned on or off. In addition,
a gear can be edited with this command, even during operation, by
changing a factor value. Dynamic synchronization (acceleration or
deceleration) is possible.
The activation of this function occurs in the user program with the FOL
command.
See also Section 6, ’NC Commands.’
To Next Page
Loading...
